Datum Systems PSM-500L Spezifikationen PDF herunterladen (Seite 73)

PSM-500/500L/500LT SCPC Satellite Modem Operation

PSM-500/500L/500LT - Rev. 0.91

Page 3-13

Unit Parameter Detail

Representation

Type

Entry

Description

Redundcy Sw Hold

.5 Sec

Numeric 0.0 to 600.0 seconds in 0.1

second increments.

Sets the minimum time that

a redundancy alarm must

last before switching occurs.

Redundcy Backup

Idle

Selection Backup Status or Press “0”

or “Edit” then “Enter” to

transfer current

configuration to backup.

View status of or configure

backup. Only available when

on-line.

Config Modem

Mod & Demod

Selection 0 = Disable,

1 = Demod Only,

2 = Mod Only,

3 = Mod & Demod

Used to disable the Mod or

Demod and also the lamps

and indications when not

used.

Config Recall

Factory, 1 to 8

Selection/

Numeric

0 to 8, 0 = Factory Location to recover current

configuration from.

Config Store

Factory, 1 to 8

Selection/

Numeric

1 to 8, Factory configuration

not alterable

Location to store current

configuration to.

Config Restore 1

After 1 Sec

Selection/

Numeric

Disabled (0), 1 to 14,400

seconds

Time after loss of rcv carrier

to restore this configuration.

...Restore 2-7

…

Config Restore 8

Disabled

Selection/

Numeric

Disabled (0), 1 to 14,400

seconds

Time after loss of rcv carrier

to restore this configuration.

Config Power-Up

Last

Selection/

Numeric

Last (0), Recall 1 to 8 Behavior on power-up.

Either the last settings or try

to lock using one of the

stored configurations.

Keybrd Mode

Full Access

Selection 0 = Disable,

1 = Read Only,

2 = Full Access

Keyboard access control.

Keybrd Entry

Quick

Selection 0 = Quick,

1 = Edit Only

2 = Confirm

Keyboard Entry method.

Quick is the normal default

mode.

Keybrd LCD Active

Backlight Full

Selection 0 = off, 1 = 1/3, 2 = 2/3, 3 =

Full

Active level of LCD backlight

Keybrd LCD Idle

Backlight 1/3

Selection 0 = off, 1 = 1/3, 2 = 2/3, 3 =

Full

Idle level of LCD backlight

Keybrd LCD Cntst

10

Numeric 0 to 20 LCD Contrast setting

Keybrd Activity

Beep

Selection 0 = None,

1 = Beep,

2 = Blink,

3 = Beep & Blink

Audible “click” and/or “Local”

LED Blink on front panel key

press.

Remote Mode

Full Access

Selection 0 = Disable,

1 = Read Only,

2 = Full Access.

Remote control access

mode allowed

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare